开云体育

Thank you. That should do it.

Any cheap USB-Blaster clone will do. You will have to make up an adapter cable as shown in the picture. -- Sid Boyce ... Hamradio License G3VBV, Licensed Private Pilot Emeritus IBM/Amdahl Mainframes

Hi Ben, It seems that all my ports are closed, in spite of the port forwarding. At least that explains why it does not work, not the "Why" they are closed. 73 Peter Op 25/11/2022 om 23:39 schreef Ben

Hi Ben, Yes, PW is set on both devices. The remote and local are both sitting on my desk, so initially I connected them to the LAN, and it worked. Next I connected the Remote to the MIFI and set the

Just an IP address, in format 123.45.67.89 ... no "http://" or anything else. Don't forget to enter the "Password for Remote Radio" at both ends ... do you see any error messages at either end

Hi Ben, Did you use the WAN IP address or URL? And in the latter case: with or without "http://" etc? 73s Peter Op 25/11/2022 om 22:56 schreef Ben Cahill:

I've connected successfully (for Rx only; did not try Tx) with a Remote Quisk rig in New Zealand (from East Coast USA) ... round trip was about 205 msec. -- Ben, AC2YD --

Hi Jim, I hooked up a MIFI unit to emulate a real life internet connection, but it did not work out. All forwarding was set as laid out in the Remote documentation, but to no avail. I called the MIFI

Hi Jeff, The manufacturer of the board seems to have ceased activities altogether, hence it is hard to get data. The only think I can offer is a schematic (but you probably have that one). Dl2STG

Hello Jim, There is no reason for it to be on Config/Tx Audio and I just need to learn to look a little harder. I missed the shift to the Config/Status screen but its a more logical place to have it

Hello all, I just joined the group. ?I had bought the hiqtrx with the Hiqsdr board quite a few years ago and got distracted back then. ?I’m dusting it off and want to program the flash memory with

Quisk runs with two threads, a GUI thread and a sound thread. You must not sleep() in the sound thread, as this thread is time critical. If you pause in the GUI thread, you run the risk of freezing

Hello Graeme, The microphone level is on the Config/Status screen along with other audio levels. Is there a reason it needs to be on Config/Tx Audio? Jim N2ADR

Hello Jaroslav, Thanks for the information. I see that I made an error on my message when I said " after a period of transmit the graphical display freezes on my remote. ". It should have been after a

Hi, I am also experiencing occasional UI freezes, but for me it happens also on the local machine (without any remote function) and even in the RX mode (i.e. no RF). For me it isn't 4.2.12 specific it

Thank you very much for your detailed analysis. I did read somewhere that the mountain in the middle is caused by bad phase and amplitude adjustment, but cannot seem to make any difference by

Hello Nigel, Thanks for the screen shot! I'm not sure what the mountain in the middle is, but the I/Q calibration is used to remove "ghost" images mirrored around the VFO frequency. In your screen

I want to thank Jim for making it easy to add a new widget, including the remote control messaging for it, in such a straightforward way. Jim leveraged his recent work with MIDI, along with Quisk's

Hello Jim, Keeps getting better, LNA slider works as you have said and is the best solution. I have one bug to report which has been through several recent versions: The Config/TX Audio screen has no

Hello Peter, Each remote radio requires a custom hardware file at the control head. There are only files for SoftRock and Hermes, not HiQSDR. I will write one for the HiQSDR when I get a chance, or