开云体育

Reading this a bit more carefully what you want is not currently possible. How are you controlling your tuner?? Via some script or your own program? It would be possible to add some sort of

What rig?? Not all support that function. Mike W9MDB

Hello Jim, Could you please give me a little more guidance to implement the "U TUNER 1" command. I have tried the following ... Rig command: U TUNER 1 set_func: error = Feature not available

The new file quisk_hardware_fifisdr.py supports the FiFi SDR hardware. Thanks to Joe, LA6GRA. I added the rig 2 Hamlib command "U TUNER 1" to control the Spot button. The Quisk remote feature now

Hello Ryan, The simplest way to do this is to just press the Spot button and have it assert RTS. This is easy from your own hardware file. That is why Quisk has hardware files. Jim N2ADR

Thank you for the responses. ?I should have been mor clear in what I want to accomplish. ?I need to be able to activate the spot function which sends out the carrier and at the same time activate

I will add this to Quisk. Jim N2ADR

Hamlib does have a "TUNER" function but it depends on the rig supporting it. U TUNER 1 U TUNER 0 Mike W9MDB

yes, but hamlib lacks a "TUNE" functionality (just emitting a carrier) and temporarily switching to FM (or AM, for that matter, but with less power) and activating PTT gives you right that. So in my

Hamlib knows nothing about audio so cannot, by itself, generate any audio. Rig in FM or CW should generate a carrier as opposed to USB/LSB with a suppressed carrier. Mike W9MDB

I have once made a "GUI rig controller" and this is how I implemented emitting a "TUNE" using hamlib: a) set power to desired value b) change mode to FM c) activate PTT at the end of "TUNE" I then do

There is currently no HamLib control for Spot. The command does not seem to exist in rig 2. What commands from the Flex ZZ list do you want to add? Jim N2ADR

Is there a CAT command for the SPOT function?? I tried the tune command from the FLEX command list and nothing.? Trying to set up something in FLRIG to control my antenna tuner.?? Also can the

I solved the IP assignment, using "sudo ufw allow in on eth1" (eth1 in my case, the nic which only connects to the HiQSR). It resulted in a new issue for the VPN though.... 73s, Peter, PA3BIY

Hello Jim et all, I have a slight issue getting the HiQSDR to work when I have a cold start up. The Quisk SW will assign it an address, which is not the default 192.168.2.196, but 192.168.4.196. This

Jim, Thank you for the explanation. ?I know its not a priority and my never happen but having the transmitter bandwidth adjustable at least out to 3k with the low end at 50 hz would be awesome. ?The

Hello Jim, Since installing quisk-4.2.13 I have (over the internet) participated in a CW contest with many short duration contacts, followed by an SSB QSO in which I transmitted an over whose length

Thanks for that. I will scope around and look for noise, but I cannot hook up a stereo headphone since the line2 USB does not have outputs.? I can't use anything for output as this is in a sealed

To determine if the spectral hump in the center is noise, switch Quisk's mode to DGT-IQ, tune to the center where the spectral hump is and give it a listen on stereo headphones. What you hear is

I got that, but the Behringer does not have USB output! Nigel Johnson, MSc., MIEEE, MCSE VE3ID/G4AJQ/VA3MCU Amateur Radio, the origin of the open-source concept! Skype: TILBURY2591