开云体育

Doesn't using ExpressPCB lock you into using their manufacturing service, at least for the first order? Thanks, Craig

Ill bore you with the physical exam yesterday. The physical therapist met us at the orthopedist's office with the surgeon and 2 x-ray techs. I thought I knew what torture was, I've now had a post

Hi everyone I just wanted to thank members for their schematic/PCB design suggestions, I am getting reasonably good results using ExpressPCB and will post the results once finished. Thanks Chris

Hi Told you Chris would be helpful Simon Hope op goes well!

The Multi-function Tester (TC-V2.12k) is good for identifying parts, testing to see if they are good, but the transistor and JFET matching function uses too little gate current for most useful

I got this one; https://www.ebay.com/itm/285523623993?var=587474074108 No case but uses a real Atmel Chip. I use it all the time. When salvaging parts from old equipment no need to identify just plug

SprintLayout6.0 Easy to use and learn. https://www.electronic-software-shop.com/lng/en/electronic-software/sprint-layout-60.html?language=en Sam Reaves ARS W3OHM Owner / Moderator of: LeCroy

I think Ethernet has great promise because of the tight twist. I did some ingress tests at a site roughly in the center of a triangle of all the Lexington MW stations and Ethernet was almost as good

In all honesty i suspect Chris will be happy to talk with you especially as you are using one of his Ethernet early models..all his now are coax due to people being scared of Ethernet/ demand. Simon

I'll risk it later today. I have to go in for detailed X-rays so they can pick the best fitting replacement joint. It sounds horrible but my right knee is so much better words fail me. A local civil

Chris is quite reasonable, ask..even if just get response its made of xyz plastic. Also the fact that his product is still as good as new is a positive remark on said group. Simon

Sorry to hear about your ongoing health issues. Hope that will be resolved soon! Sorry if you know that already but you can use octopart.com if you need to find Hammond boxes (or any other

Thank you! These are exactly what I'm after. I'm trying to decide if I should go ahead and try to upgrade or wait until after I'm fully mobile. I had total right knee replacement in early June and

I'd be concerned he'd think I was intruding on his patch. I have zero inclination in going into business but Chris might feel threatened or insulted I was modifying one of his products. Engineers can

Some choices for polycarbonate here: https://www.hammfg.com/electronics/small-case/plastic/1554?referer=1355 https://www.hammfg.com/electrical/products/non-metallic/pcj-hsc Simon

Ask Chris himself on ccw group? Simon

Most use cheaper ABS, but it doesn't last. Find enclosures made from Polycarbonate. Regards, Martin

I hate replying to myself but I wanted to apologize for the mixed font size. I wrote it in MS word in dyslexie font all in size 14. Sorry it's difficult to read.

I thought this deserved it's own thread. A quick report on the Multi-function Tester (TC-V2.12k) https://www.circuitspecialists.com/content/430516/csi-tc1.pdf They is very functional, it quickly

I have used many schematic capture and PCB layout programs professionally over my 40+ year career. (In fact I started with a drafting board and tape on mylar on a light table in the 70's LOL). For my