开云体育

If they are not available where you want to buy them, your remaining options are wait until they are in stock, do without, build your own or where ever you found the scalper prices - try to make a

Thanks for the reply. Where is the fuse? I can't find it in the schematic. Yes, there are 13 volts on the regulator input.; moreover, touching the strip that connects the LED card with the

is there a fuse inside the tuner, maybe you missed?? did you check the 7805 with a voltage check?? do you have the 13 volts on the primary side of the regulator, or is it lower Dave Garber VE3WEJ /

I made my y-acc-3.? ?Use a db15 male connector and a 3.5 mm speaker plug.? tip goes the pin 11 and ground goes to pin 3.

Folks, years ago, when I bought the RT100 I prepared a Bias-T as per the Rev. C of the manual, where the power was applied continuously to the tuner. While reviewing the schematics (v 1.2) posted on

Hello everyone. I have an AT100 pro II that suddenly stopped working and won't turn on anymore. It does not cycle through the LEDs on startup and does not respond to any key presses. I checked with

I don't understand why anyone would pay scalper prices for this item. On both Gigaparts and DX they will sell for under $13 and, even though they too are sold out, they sell for $10 on LDG's site. I

Opps!! Miss read the manual . . . sorry. But still won't pay 4x's the price for them.

But wait, there's more..... On power up, the RT-600 will not tune upon application of RF power, nor will it retain the last good tune.? The SWR is always high right after powering up.? It is as if

Got it too. I don’t need it – NOW. But I have two RT-100s here, neither being used right now…….. and it may come that I need a schematic someday. THANKS EVERYONE !!! Vy73 – Mike – KD5KC

Thanks a million AL. Found what I needed... Dennis N0SMX

The schematic is in the Files Section on here. Al K5TAN Sent: Saturday, March 11, 2023 3:37 PM To: [email protected] Subject: Re: [ldgelectronics] RT 100 schematic Mike thanks but I have the

Mike thanks but I have the manual also. I bought this tuner new in 2016.. If I find a schematic I'll share it with you.. Mostly what I'm finding out is non exist for public distribution.... Dennis

I have the manual in .PDF, I’ll share if you need it. I have no schematic. If anyone does and will share….. Please—ME TOO! Vy73 – Mike – KD5KC – WRFF851 – El Paso – Texas – DM61rt.

I have found some of these cables on eBay. Your mileage may vary. Phil Laird, WI5O

Does anyone have a schematic for the LDG RT 100 remote tuner. I have an issue with mine and found a burned resistor on the board.? I can't determine the valve to replace it with.. Thanks in advance

Still on a national backorder.? No ETA from LDG as to when they may become available.? You may see some dates listed on some of the retailer websites but that is generally just an computer algorithm

I would also like to use a LDG 1000 with a FTdx 3000 but would like to use the TUNER port on the radio instead of the LInear (15 pen) port.

did you go into the operation settings and change the internal tuner settings?? Dave Garber VE3WEJ / VE3IE

Hello, I'm back with some additional questions about EXPECTED behavior vs ACTUAL behavior. I built the cable I shared the schematics for a few weeks ago. I thought it was working properly, but I'm