开云体育

I believe most yeasu HF rigs like FT950, FT 1000mp mark V and FT 2000d have a db25 serial jack and a din jack for linear. Is there a cable pin out gor these primarily want it to auto tune the Pro 1000

Found a photo of it. The IC-706 Mk-IIg radio face was hung from under the top shelf. The IC-706 Mk-IIg main chassis and the LDG tuner was up above the shelf just above the face. And the Power supply

IC-7000. I -=THINK=- I have a tuner here in a box somewhere, an LDG-7000? It was made to work with the IC-7000. The IC-706 has the same tuner interface, and this “7000” (if that is the right

Thanks! -- 73, AB1PH Don Rolph

I have run the LDG Z100plus tuner for 7 years with the IC7000 mobile.? The tuner reads the frequency by RF.? Every band change or frequency changed out of the memory channel saved will prompt the

I presently have an IT-100 tuner. What tuner do I need which will detect the new frequency and select the correct memory location for that band? Thanks in advance. And have a happy and safe holidays!

It seems to me it does a memory tune and then goes to bypass. Tex ka5y

Best I can tell, if it thinks the best SWR is without it intervening it will go to bypass. If it's not intended behavior though that would be good to know. Seth Beckman beckmanseth@...

I experience the same behavior when using my hexbeam on certain bands.? My interpretation is that the tuner determines the antenna is is at it's best match with the tuner bypassed.? If my SWR meter

I have the AT-1000 Pro II and it sometimes jumps to Bypass after tuning.? I hit C Up and goes out of Bypass.? Not too concerned as it tunes OK.? Just wondering if anyone has noticed the behavior??

You will be successful! I’d like to see how you split the tuner! I do very much like you are thinking about, only at the 100-watt level. I run battery/solar, using 2 x 100Ah batteries and 400-watts

I hope to find time to experiment with this in the near future, and will report results, success and fails. Random length, very long balanced dipole, balun, tuner. Tuner and dipole feed point same or

ft7800 with tt4 ic705 on the amp and tuner inside a pelican case do a lot of POTA. kelly K7mhi

RM Italy…DX engineering is one source. 73, Frank K4FMH --- Frank M. Howell, PhD Ridgeland, MS frankmhowell (at) hotmail.com ---

What is the radio in the left? And is it for the TT4?

Sold internationally various resellers https://www.rmitaly.com/en/product/mla100-2/ kelly

How did you check the relay contacts? I need to check some in another tuner. Al K5TAN Sent: Thursday, December 8, 2022 11:46 PM To: [email protected] Subject: Re: [ldgelectronics] AT-1000ProII

What kind of amp is that? Are they on Ebay? Alex Netherton http://blueridgediscovery.org [email protected]> wrote:

Thanks for your reply, Alezis! The "High/Low" relay works when I tune manually. It also works automatically after I save my manual setting to memory and recall it later with a short press on the Tune

You are welcome Tim.?? BTW, I have used this tuner with my TS-590S for many years for tuning my homebrew 80M Doublet and GAP Titan vertical antennas.?? I always tune using 5W.?? I relocated to