开云体育

Na Power supply solid 13.8volts not checked amps though yet [email protected]> wrote:

",sometimes it wipes the operating frequency completely off the radio display" That statement makes me wonder if you don't have a current draw/PS issue. The tuner has no way of messing with the

Al no I’ve not changed antenna config,sometimes it wipes the operating frequency completely off the radio display ,and tuner switches to bypass mode ,today I’ll give the Tuner Manual a good

I thought I remembered a reset process from the unit I had for a while but looking at the manual I see nothing. Sorry. Sent: Thursday, August 22, 2024 7:36 PM To: [email protected] Subject: Re:

Thanks Al I will try tomorrow now 00:34am ,thanks for reply ,I didn’t know I could reset tuner ,Dave 2E0DTB 73 [email protected]> wrote:

My take would be the tuner can’t tune the load. Did you accidentally change the antenna selector on the tuner? What happens if you set the 7000 on CW at low power, key it, and hit the tune button on

Hi Mike If the power M1000 doesn't work with the tuner you can get the working tuner firmware pic chip free from LDG, to make the data port work again, Dave 2E0DMB [email protected]> wrote:

Guys I hope you don’t mind me hopping on this thread,I have an Icom 7000, i too have have an LDG AT-100Proll Autotuner ,I’m using the supplied interface cable from radio to LDG Tuner,all was fine

Hi Dave, and thank you. I seem to recall in some instances there are different versions of tuner and manual. I also seem to remember some discussion about the M-1000 meter not working on some

Hi Mike You can download the manual from the files section, Dave 2E0DMB [email protected]> wrote:

Good afternoon all. I feel superbly blessed today. A good friend, I’ve known him for 40 years…… when I retired from the Army he helped me start a second career…. we worked together as power

Here's the file.

Thanks for the proposal! I had similar thought, since the LDG has 1MOhm pull-up resistor before the comparator, but the simple dummy-tuning schematics (like I attached in my previous reply) operate

My second post, with the attachment is not showing up. You need to add a 43K resistor between pins 2 and 3 of the molex connector for the G-model. It can stay for the non-G model also. The non-G model

Thanks for all aswers! In case of I connect this very simple curcuit to the radio (almost the same like yours), the radio can be controlled, it transmits the 10W CW signal for tuning. From my

I found it quicker than I thought. I have attached the reference. Al Sent: Thursday, August 22, 2024 1:02 PM To: [email protected] Subject: [ldgelectronics] Icom IC-706MK2 IC-706MK2G vs LDG

IF I remember correctly, here is a difference in the radios. Some need a pullup resistor and some do not. LDG my have that information. I will see if I can find the reference. Al K5TAN Sent: Thursday,

The only communication from the radio to the tuner is via the tip of the radio plug on the tuner. When it is pulled low it signals the pic controller on the tuner to initiate a tune cycle. The ring

Hello Everyone, I sent an e-mail with the below content to the LDG by Today, but maybe you have ideas about the issue of my equipment. I need your kindly technical support, which is belonging to my

I have found LDG to be one of the most proactive as far as customer service goes. I have sent an email on a Sunday and gotten a reply in a couple of hours. I was not expecting anything until Monday at