FYI Everyone - I did the full reset on the AT200Pro of holding
down the three buttons, while applying power through the DC 12V
plus in the back ... It did reset!
No help. :-( I still get "all the SWR LEDs blinking" when I try
and tune on either 80m or on 6m, whereas with the Z100+, it easily
find a low (1.5:1 or better) solution on both 80m and 6m.
I will say the AT200Pro works fine on every band 40M through 10m
... It is possible, perhaps, that certain of the values of
inductance or capacitance (certain relays?) are broken, resulting
in the apparent lower tuning range of the AT200Pro compared to the
Z100+ ... I did, after all, buy the AT200Pro used ...
Off to LDG it goes, let them check it out and either:
- Verify it's working 100% to spec and confirm I have a mystery
- Fix it. :-)
--
de K4ED in FM09
QRA: Mark Sunderlin, QTH: Winchester, VA
"Never forget XYL Z as a factor in antenna efficiency"
