Baby gates
3
Here is what we did for our grandson We used phiphertex and sewed a vinyl edging all around to make it stronger. Covered both stairway and made one for the poet forward bunk. He was 1&1/2 when he visited and the gates were tested many times by him several times and they held well! LaDonna THOMAS s/v Beagle Knot Tel: +1 (340) 227-6094
|
Lagoon 410 solar panel wire install
5
I have a 2005 Lagoon 410 S2 owners version, with a hard bimini. I am going to add solar panels to the bimini and am looking for advice on running the wires to the batteries below. I hope to run the wires from the solar panels through the stainless pole support for the bimini, on the aft port side, so it would enter the aft port stateroom just about where the outside engine access (to pull the engine) would be. I'm looking for advice from any 410, or similar owners who have run the wires to your house bank, on the port side. Thanks
|
2017 Lagoon 450F for sale - USD 579.000
Hello, after crosing the Atlantic last year, I have decided to put my catamaran on the market. She is very well equipped and in a pristine condition. For more information please go to: https://yachthub.com/list/yachts-for-sale/used/sail-catamarans/lagoon-450-flybridge/216330 If you have any queistions do not hesitate to ask, regards, Martin
|
2011 Lagoon 400 number 101 for sale in Australia area
2
Hello fellow group members. After 3 years of cruising we will be selling our lagoon catamaran Sanuk. You can find very detailed info on our blog site: https://svsanuk.com/sanuk-for-sale-at-end-of-2018/ We are selling Sanuk privately. Although we envision a sale by october of this year, we are open to negotiations before that. We are cruising the Vanuatu/Solomon/PNG islands before going to Australia. Thank you Stefan
|
Speedy Sleeves for Yanmar SD31 shaft
Hello, we like to put Speedy Sleeves on our shafts in the area of the simmerring. http://www.skf.com/de/products/seals/industrial-seals/power-transmission-seals/wear-seals-skf-speedi-sleeve/index.html?designation=99315 The SD20/30/31 seems to have the same diameter, what is the dimension ? Where to buy in the USA ? Did anyone the job ? Does it work ? Regards Johannes Lagoon 410
|
looking for an new or used mainsail Lagoon 410
Hello, any help in a new or used mainsail will be appreciated. We are sailing this summer from Bahamas up to New York, and will be in Deltaville in August/September. Johannes Lagoon 410
|
Battery Charger L400
Greetings all One of our shore power battery chargers a has stopped working and after discussions with my Sparky I need to get another. My preference is for an original one. It is a Cristec CPS 12V 40A. Anyone know a good source for these? We are in NZ so freight may be an issue. Any pointers would be appreciated.
|
2016-17 Lagoon 42 owners
8
Looking for new owners of the 42 to chat about issues specific to the new lagoon We have Hull 142 and currently sailing all of Florida west and now up east coast.
|
flexprops experience
2
I have a set of Flexofolds from my 2012 L400 that I changed out. About 1100 hours work great. Pics available if interested. These retail for $4K from the Swedish manufacturer. I'm selling for 1/2. Located in Ft. Myers, FL area.
|
[LagoonOwners] Raymarine St wind vane cups replacement
You can quickly estimate the wind speed quite accurately looking at the surface of the water. I am not sure why a wind speed indicator would be a critical item.
|
Raymarine St wind vane cups replacement
Well a big bird landed on my wind cups and broke one off. I was told there is a replacement kit for cups and wind vain but not found a compatible one for st70 at Amazon, Defenders, West Marine. Really really need to locate quickly as we are due to set sail, but not wanting to without a wind speed indicator.. Any help greatly appreciated. Thanks
|
twin helmseat manufacturer - question
2
does anyone know the manufacturer of the helm seats posted in the sites photos on oct 7 2017 by captn jbk? they are just what we need. thanks, tim and tracey ramsey s/v folie a deux
|
|
flexprops experience
5
I am thinking of replacing my max props (in need of serious reconditioning) with flexfold. Yachting magazine did a comparison of various folding and feathering props Folding and feathering propeller test and the flex props both 3 and 2 blade performed very well. Does anyone have experience with flex fold? I am thinking of the two blade because it is lighter and less expensive. I have a lagoon 380 with yanmar 3gm 30 with 3300 hours and sd20 saildrives. Any advice would be greatly appreciated Chris and Pam Wild Aboard Wildcat (lagoon 380 hull 85) lying Hampton Virginia Folding and feathering propeller test Which is the best folding or feathering propeller for you? Emrhys Barrell compares 15 props in a test of speed, ...
|
reef point - blocks or low friction rings?
8
hi all, Just been having a good look at my sails (L380S2) and I noticed that almost all of the blocks that hold the reefing lines in place are cracked to some extent. most of these have cracks in the "wheel" of the block which i only noticed when I took the reefing lines off for replacement. Rather than replace the blocks directly, i was thinking about replacing them with low friction rings. Has anyone done this? if so, did you just use the dyneema strop and loop it round the ring on the sail or use another method? Thank you for sharing your advice and experience. Marc
|
[LagoonOwners] flexprops experience
I have Flexofold 2 blade on my boat. My Lagoon, being the predecessor to the L380, has shaft drive. I found that the 2 blade have more vibration and noise then my fixed props did. I believe that most of this is related to the shaft drive and may not affect a sail drive the same way. If I had it to do over I would have gotten 3-blade. All other aspects about the Flexofold are fantastic. Motoring performance is better then my fixed 2 blade. Reverse works the same. I've run charters for 12 years so I pull into docks a lot! Rick s/v Mai Tai L37 TPI
|
[LagoonOwners] flexprops experience
Hi! I have two Flexofolds for 9 years on 75hp Yanmars, no problems and good performace. ANdrej
|
Facnor furling FX4500 + bowsprit Lagoon 400
Hi mates, Technifurl sold. Now, I only have the furler Facnor 4500, bowsprit and sheets (all like new - 2 times usage). 1500€ Regards for all Jo?o Santos
|
[LagoonOwners] Re: replacing rudder
I have a bearing replacement coming up but more important is replacing the rusted "quadrants" or arms that the link bar and autopilot ram connects to. Is there an off the shelf option or do I need to have them made. I am not even sure how successful I will be in removing them. Rick Cooper 38 South 380 #005 Currently Lake Worth going to Green Cove Springs
|
replacing rudder
4
Has anyone had to replace a rudder on a lagoon 380? chris wild aboard wildcat
|