开云体育

I had this with a 380. Just use marine ply, cut to size and epoxy over it (or use a two-part epoxy paint of your choice). The cut can be a little trick with the curves, but it's a relatively cheap and

Is this familiar to anyone with a L400? The board that runs across the anchor locker on my 2012 L400 is rotting. It appears insufficient fiberglass was applied and/or some water got under the glass

Hello. There some smal 10A Fuse under the bed. in the back cabin. The smal Alternator wire and also the Engine Fan goes over this fuse. Disconect the van before you change the fuse. Mostly the van are

On L400 the fuse is inside the service batteries compartment. It usually fuses due to a faulty relay that is close to it, or due to a faulty port engine blower. Check the relay first.

On a 400S2, do you know where a fuse or relay for the starboard battery isolator is? Our starboard alternator alarm is on. The alternator is not working because it is not getting power from the

Would you mind telling what are 'crazy'? prices in Croatia for lift etc are just to see the extent of the issue ? Also, what is the quality of services there ?

We lifted our Lagoon 400 in northern Italy in the San Giorgio di Nogaro area for the same reason you mentioned. ?The short hop from Croatia to italy saved us a ton of money. ?Both yards in the San

Try the yard at Brindisi.? Quite reasonably priced last time we enquired and good reports.? Alternatively, how about the Cleopatra at Preveza, Greece. Good luck.

Dear fellow Lagoon Owners ; The start of the 2018-2019 Panama Posse is only a few weeks away. The second annual “Panama Posse” rally sails to seven countries, including Mexico, Guatemala, El

Can anyone advise where I can get a Lagoon 450 lifted and cleaned on east coast of Italy? Prices in Croatia are crazy and it will be easier and cheaper to sail across. Many thanks. Nick

Please see the forwarded email regarding an apparently stolen boat near portugal. Rob Denney (designer of the boat) would probably be happy to be the point of contact. His email is below. Thanks -(not

Thanks everyone for the help! Now in Mayotte headed to Tanzania! Will try to have one fabed

Bronze would be a good idea ! What about stainless?

Guys, thanks for your input.? What type of continuous furler do you recommend?? Are they rigged for multiple sails?? We have a bowsprit and light and heavy gennakers with socks and it looks like a

I used two spinnaker blocks on the bow and a large steel plate underneath to distribute the load rather than the loop installed by Lagoon. Thanks for the advice though. I also use a block off the bow

something has to be off. maybe the lift scale. if the light load is 7k kg less than what you are at, which is supposed to be with all tanks half full, and you have 7 tons of extra weight, don't see

Last time we were on scales it showed 14.4t. With full water and fuel tanks. We have genset that adds weight.

David, Are your attachment points on the bow reinforced for the Parasailor? I have a 2009 Lagoon 500, and the attachment points on the bow are simply bolted on with three bolts and no backing plate or

Recently I have asked lift operator to check boat weight and it was 17,000 kg. I thought my boat is lightly loaded with around 2-3 T above light weight. If that is true, empty boat weights around

Prior to hurricane last year there was a great little restaurant on Pomato Point on Anegada BVI. ?Does anyone know if the owner/restaurant survived and is it back/still in business. ?Favorite