¿ªÔÆÌåÓý

Thank you!

Mack Sails Quote in Stuart FloridaLagoon 450? ? ?All standing rigging with Pelican Striker wire and fittingsUnder $12,000.00 including labor to remove and install in the air and tune.East coast of

Are you looking at an inspection report or are you just replacing your rigging because it's 10 years old? Joe Sea Of Love L440 BVI

Hi Steve, Are you saying you need to replace your standing rigging after 8 years?

Has anyone recently had their standing rigging replaced and if so where did you have the work done and what did it cost? I received a quote for 24K. Thanks!

It's all about the Adventure

I had one for an L400 made from polycarbonate (Lexan), about 6mm as I remember.

I believe L410 is 8mm acrylic. Same material as hatch lens. Probably the same for L380. ¡ª- David

Has anyone sourced the large windows on the L380 (2007)? The factory price has just doubled (now ?1000 each delivered!) and I thought I'd look into sourcing them from elsewhere. I've got the outline

On my 2004 410 I have line sail bags made by a company called NV Industries. When I went to their site low and behold they make enclosures for several Lagoons as well.

I did it carefully and put it in place with a bit of glue. It is only a thin plate.

Steve in Solomons MD 2004 410 S2 E

I purchased the rubrail through Lagoon: Just 70€ per side for Lagoon 380!? Shipping cost more than doubled this. It fit into a large platic tub as found in hardware stores. I added hot water and

I¡¯ve done it and helped a friend do his. The rub rail is very stiff and impossible to install unless you heat it. Two methods work great: a heat gun or, a huge boiling bowl filled with water heated

Has anyone else replaced the rub rail on their sugar scoops? Anything I should know or do? Was wondering if there was a sealant or adhesive I should be using. Thanks in advance, Steve in

We have a leak in one of the salon top grab rails.? Water enters and leaks into the salon from one of the backing cover plates. Has anyone any ideas on removing the backing plate without damaging

Hi..I am looking for a source for the puck lights for the L420 2007.? These are the ones overhead of the births and have a little switch.? They are tension mounted in the ceiling.? I can find

Hi, Has anyone had problems with these windows popping out - either completely or partially? If so, how did you fix that? Fair winds, Glen

I used #m 3M adhesive remover, immediately after removing I diligently washed window with a mild soap water mixture to remove any residue. I had no issue with streaking or melting of window from the

I need to replace the thrust bearings and dripless seals on my 2004 Lagoon 43 PC. While I'm pulling the prop shaft, I'll also replace the cutlass bearing. From what I understand, this is a fairly