开云体育

You don't seem to have any holes in the pads you may also find it easier to see if you turn off the outline mode ANdy "Lctech Lctech via groups.io" <lctech3000@...> wrote:

To me it looks like pins 3 and 4 of SW1 are not connected to anything in the schematic, and therefore shouldn't be connected to anything on the PCB. If SW1 is one of those where 1 and 4 are

Hello, I have a problem with manual but also automatic route track design. As in the attachments, the design rule checker shows some errors. I tried sofar to change the values of the erroneous space

Hi Friedrick. Exactly which Omron relay symbol and 3D you are you searching for? May be I can help you.

It's very easy now. Open the file in the footprint editor, check and adjust if required. Then select save as. This will allow you to choose the library into which you want to save the

This is helpful!? I'll have to read up on how to properly import these. I appreciate this good intel. Never knew about the ECAD but I can see how it will be very helpful, rather than needing to

Frederick, I took your Phonenix part number and searched for it on Mouser...? Just below the Datasheet link is a link to ECAD Model where you can get Schematic Symbols, PCB Footprints, and sometimes

Right now I'm on Windows 10-pro. I'll be upgrading to 11-pro in February, when I change out several PCs. The only symbols/footprints I have installed are those which came with the download

I'm not a moderator on this group, but if I were, I would mildly rebuke you for replying in a thread and changing the subject. This does not create a new topic and merely messes up message threads for

Neither am I, Gen

Hi All thanks for your tips, Barry 75 [email protected]> wrote:

You don't mention what operating system you are using. There is a large repository of symbols, footprints and 3D models. I'm slightly surprised you don't already have it installed. BTW, you're not

Kicad comes with a huge library, and as chris says it's quite easy to make the footprints and symbols you need. However kicad has gained so much traction now that the major component vendors, mouser,

Hi, Welcome to KiCad! A lot of symbols and footprints are installed by default along with KiCad. SOMETIMES what you need will be in there - but when it is not, it is quite straightforward to *

I'm very new to KI, but used Eagle a long time ago when I was still in practice.? At 71 years old, I'm getting back into the swing of making boards for my hobby. Is there a repository for symbols

Hi, I'm trying to create a P-shaped pad by editing a pad as graphic shapes. I've created the required outline as a set of straight lines and arcs, but when I convert these to a filled polygon, the

It all depends on how easy you want the user to make the selection... Zero ohm or two pads close together require the user to have basic soldiering skills and access to those tools...? Do you really

I installed v8.06 and installed kikit via PCM then when I tried to run the PCB editor I go the prompt to install kikit via the Kicad command prompt as usual. I entered the command "pip install kikit"

That's it! Who would have guessed? Thanks very much. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

I had a similar problem until I realised that I had to hit the "Export" button at the bottom of that window. I hope that helps? Luke