开云体育

Thanks for the reply Erik, The footprint is currently assigned to every group, and yes, the location of each member of the group is totally arbitrary.? The main center pad(1) is the active pad with

... If the depicted 4x1206 assembly is in your library as a single component, then I'd just set its value to: 100pF + 47pF + 47pF + 22pF and add a line of e.g. awk to split that up into 4

Hi all I'm drawing up a Low Pass Filter for a HF power amp. The topology of the filter requires some parallel capacitors to achieve the required capacitances. In most cases 4 capacitors (sometimes 6)

Ouuu, Little bit hidden settings. But, it works now. Thank You! Regards Peter ?t 10. 10. 2024 o 9:48 Tony Casey via groups.io <tony@...> napísal(a):

Hi Tony, Thank you very much! Everything is Ok. Best regards, Varuzhan

Like this: -- Regards, Tony

Please see message #25275 </g/kicad-users/message/24275> -- Regards, Tony

Try this: 1. With the Pin Table visible, right-click anywhere on the column header row. 2. You should get a checklist of columns to make visible. 3. There are 14 available columns - some are not

I checked on my installation, but the PinTable is missing the Y-Position column (see attached image) :-) Something is wrong.... KiCad v8.0.5, release build on Windows 10 Regards, Peter [image:

Here is the screenshot

I use W10 on one PC and W11 on the other. The "Pin properties" is Ok, the problem is only with the "Pin table". Regards, Varuzhan

It is there on KiCad 8.0.5 on W10.

I'm on Linux. As you can see, everything is fine here. Must be something with your installation. Perhaps you can share your screenshots. -- Regards, Tony

What OS and version are you using? We need more data. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

I noticed it starting from 8.0.4, and continuing in 8.0.5.? Moreover, I just checked my second computer, with KiCAD 8.0.5 installed, the pin length column does not exist as well.

It would be helpful if you said what version you're using. I'm using 8.0.5 and the Pin Length is still there in both the Pin Table and the Properties panel of each pin. -- Regards, Tony

I noticed, that in the new releases of the KiCAD Symbol Editor, disappeared the Pin length field in the Pin table. Is the just a mistake and can be the problem cured?

Close, Kerim, but no cigar! I've been experimenting further, and it seems that if a sheet pin is connected to more than one pin in the sub-sheet (in this case there are three paralleled capacitors

For instance, it happened to me once that I duplicated a pin at the same place by mistake. Apparently, nothing looked wrong. But this gave me a continuous warning no matter what I did... till I

I tried putting a disconnected line on V5DRV, and also a line to a no-connect flag, but neither was acceptable to the ERC. I've also tried changing the pin type (input, passive etc), and connecting