Hi all
I'm drawing up a Low Pass Filter for a HF power amp.
The topology of the filter requires some parallel capacitors to achieve the required capacitances.
?
In most cases 4 capacitors (sometimes 6) will make up to final result, for example, 100p, 47p, 47p and a 22p = 216p (pretty close to what I need)
To create a complete BOM using the component capacitors, I need to include each capacitor in the schematic ... no big issue except for the footprints.
?
I was using multi component footprints to make it easier to position the capacitor group on the PCB (as per image embedded).? If I give each capacitor a single footprint, then it starts to get pretty messy with overlapping pads in a confined space.? If I give each capacitor a multi component footprint, I have a huge number of footprints layered on top of each other, also not idea.? Below is the type of footprint I'd prefer to use ...?
?
My question is; What is the best way to achieve a clean PCB design and still have a comprehensive BOM?
?
Luke Vogel