I would:
* Place the ATtiny404 schematic part as usual,
* Associate a new footprint with it, that you create, that is the
footprint of your carrier board. Make sure the pin associations between
the carrier board footprint and the ATtiny device are correct,
* Save the footprint in your personal footprint library for future
use/re-use.
toggle quoted message
Show quoted text
On 1/19/2025 10:30 AM, hanz YL3JD via groups.io wrote:
Hello,
Question about pcb transferboard.
I am using an Attiny404 smd but i solder it on a pcb transferboard.
How should i set this up in Kicad?
Thanks,
hanz
