开云体育

As new WinKeyer USB (EU version by Kanga Products) user, I found 3 items in the "Keyer Configuration" section which are not documented in the WK3Tools Operation Guide Rev 1.0 (March 27,2017): -

Okay thanks.

To be clear.... if you running in WK standalone mode, not connected to a host application... which is not what you said... you press either paddle to end the message. yahoo.com@groups.io> wrote:

Press a paddle yahoo.com@groups.io> wrote:

That’s what I would like to do as well but the ESC key nor the DEL key will correct my problem. Neither will all the ferrite cores available. I too run ACLog and my set up sounds similar to yours

From N3FJP's website: "To stop sending CW, from the main form, press Esc." Furthermore, I primarily chase DX, often in pileups.? I have Function key F1 programmed with my call.? F2 is "TU5NN.? If

Be careful of using the ESC. I was basically called a dumb a*s for using it and I should use the DEL key instead. Pat – KZ5J Sent: Monday, March 24, 2025 12:42 PM To:

I thought I was clear.? You are the "application" developer.? Forget that the keyer is connected to a computer.? I press a button on the keyer.? It starts transmitting a message.? During that

Pressing the paddles will stop a message if the application supports that function. Some apps support it and some don’t. You would have to contact the application developer to find that out. Steve

I usually use my Winkeyer USB with N3FJP ACL control, but this requires ACL to have focus.? I have similar messages in the keyer itself and can of course send them with the buttons. When using full

Ok, good show. Steve K1EL

Hello, ? ? I have a K44 CW keyboard doesn’t work properly. When I use my keyboard it sends three letters at a time. Is there somewhere I can send it to get repaired? Thank you WA4JYX?G.

Hooray!!

OK - problem solved.? I built a relay driver using a MPSA92 transistor (PNP).? It saturates at a base current of 3 ma. so that's all the Winkeyer has to key (at 13.8VDC).? No sign of failure with a

The SSRs in WKUSB are rated at 120 mA max, that could be the issue right there. You could verify with a milliampere meter. I suppose you could employ a driver stage with a more robust transistor. Be

I misread the relay label - it's Totsu CX-600.

It's a Totsu CX800, 160 ma., 12V.? No idea about the minimum current and voltage to keep it closed.? What's the max on current and voltage for the Winkeyer? Floyd - K8AC

What is the spec on the relay you are driving? Current and voltage to keep it closed ? Steve K1EL

Winkeyer USB with the updated chip at revision 31.02 I'm trying to use the Winkeyer USB output to control a 12VDC antenna relay.? Right now I'm just keying it manually, not from the PC.? With the

Steve, looks like both of them are 30.09.