开云体育

Upgrade from 4.11.2 to 4.12 failed

[email protected] All Messages By This Member #150329 I have upgraded many times without problems, but my latest upgrade has failed. I am running on a Toshiba C655, Win 10, Java 8 181, with a Locobuffer USB connected to a Digitrax DCS 200. No error messages or DOS window appeared during or after the upgrade. While my roster opens, I can neither pop open a throttle nor program on the programming track. Preferences are set correctly for the DCS 200, Locobuffer USB, and Loconet, yet the top of the roster page has them set to Internal, and trying to change on the roster page to Loconet won't save.than? Also programming mode defaults to paged mode rather than direct byte. Interestingly, to me, I can use Monitor Slots and clear slots. Would it be worthwhile to try upgrading to 4.13.1?? Joe P.
Dave Heap All Messages By This Member #150370 开云体育 Have you checked the settings In Preferences->Defaults. Nothing should be set to Internal. Upgrading to 4.13.1 will do no harm, but it won't solve your problem. --? Dave in Australia The New England Convention 2018 toggle quoted message Show quoted text On 8 Aug 2018, at 11:00 AM, diesele645@... wrote: Preferences are set correctly for the DCS 200, Locobuffer USB, and Loconet, yet the top of the roster page has them set to Internal, and trying to change on the roster page to Loconet won't save.than? Also programming mode defaults to paged mode rather than direct byte. Interestingly, to me, I can use Monitor Slots and clear slots. Would it be worthwhile to try upgrading to 4.13.1?? Joe P.
[email protected] All Messages By This Member #150373 Dave, thank you so much, except for the command station, everything was set to Internal. I now have control of track power and use of the throttle. It's too late tonight for me to try any programming here in eastern Pennsylvania. I will try some tomorrow. Thanks again.

Previous Topic Next Topic