Bob,
MY EBII doesn't offer feedback thus I'm not sure how valuable the
following will be;
packet: ef e 7c 67 0 40 22 0 0 0 3a 33 33 5d
Write Programming Track: Write Byte in OP's Mode (NO feedback)
Setting CV1 of Loco 8226 to 58 (0x3a)
packet: b4 6f 40 64
LONG_ACK: The Slot Write command was accepted blind (no response will
be sent)
packet: bb 7b 0 3f
Request data/status for slot 123
packet: e7 e 7b 4 40 7e 44 4 68 8 7f 33 33 8
Read Fast Clock: (Data is Valid)
Running, rate is 4:1. Day 8, 0:0. Last set by ID 0x3333
Master controller implements LocoNet 1.1,
Track Status is Off,
Programming Track is Available
packet: b4 6f 1 25
LONG_ACK: The Slot Write command was accepted
Bob
--- In jmriusers@y..., Bob Jacobsen <Bob_Jacobsen@l...> wrote:
I'm away from my layout, and just discovered that I'm not sure how
to
do Digitrax ops-mode writes to a _short_ address. I've just been
working with long addresses so far, but need to write the handlers
for decoders addressed via the short address.
I'd appreciate it if somebody could send me a trace of a an ops-
mode
write from a throttle to a decoder with a short address. It
doesn't
matter what type of Digitrax throttle, what CV, what value, or what
address so long as the decoder address is 99 or less and it's an
ops-mode operation.
Thanks in advance.
Bob
--
--------------
Bob Jacobsen (Bob_Jacobsen@l..., 510-486-7355, fax 510-495-2957)
Am away from Berkeley, responses will be delayed.
