Jon,
Drop me a line off-list if you wish to test out version 2 of the AD4
programmer. With Bob's help, I've moified the address mask and
revised the AD4 Pane. Addressing now works as it should - excpet one
can program the none existant address 64!
I've yet to configure sliders and radio buttons for mode selection,
but the changes I've made may eliminate the problem your having. I'd
also like a second opinion on the changes I've made.
Black Bart (Bob)
--- In jmriusers@y..., "Jon Miller" <atsf@i...> wrote:
Snip, Snip, Snip....
Now on to this morning testing. Probably happened yesterday
but it was
so hot (triple digit) I wasn't thinking. When I bring up the AD4
pane and
do a read it seems fine, but I can't then change the address. I
must exit
and then come back up to change the address and then the LED's
flash and the
address changes to 0. i.e. any attempted write seems to reset
the address
to 0.
Am I have cockpit problems?
Have you remade the decoder index?<
'tools'--'create decoder index' Yes I did that.
I use the individual CV programmer as it always works to get
back to a
starting point (an address) again! Using the individual CV
programmer to
enter numbers and using the program to read back the address
results in
correct card numbers.
--------------------------------------------------------------------
--------
------
Even though Paged and Register Mode are set to "no", I've noticed
that
they are still selectable on the bottom of the programming screen.<
And they do lockup the programmer as I have forgotten to change
it a few
times. Testing the new file Bob sent and nothing seems to have
changed.
The red LED also flashes during read which is not supposed to happen
according to CVP. They say it only works when programming on the
main
(curious).
--------------------------------------------------------------------
--------
------
>I've found that Digitrax systems will operate switches
numbered
greater than 999.<
This might depend on how we define 999. I checked with Don C.
on the
Digitrax site a few months ago and he confirmed 999. BUT it may
not have to
do with the actual addresses but how many are stored and this is a
question
I have asked on the Digitrax list.
--------------------------------------------------------------------
--------
------
Changing CV7 recognition to 62 allowed it to pick up my AD4.
--------------------------------------------------------------------
--------
----------
error in the decoder-config.dtd file<
I don't seem to have this problem with the new file!
Jon Miller
AT&SF
For me time has stopped in 1941
Digitrax DCC owner, Chief system
NMRA Life member #2623
Member SFRH&MS
