I have a turnout that requires a 2-bit operation: two outputs for each direction (straight or divert), with pulsed output signal (on two outputs).
"Divert" or "Straight" are driven by two separate inputs: either of them pulsed.
?
For example: if Sensor_001 is pulsed 'low', then output Turnout_001 is pulsed 'low'. If Sensor_002 is pulsed 'low' then output Turnout_002 is pulsed 'low'.
Turnout_001 and Turnout_002 are two bits for the same turnout.
?
How should this be programmed in LogixNG? I am lost with all the possible parameters ("Add"/"Item"/ "Sensor" or "Turnout" or "Sensor Edge", ...
?
Thanks for any help and/or references,.. !
Erik
?
Erik84750