My bad. Found it on page 72 of the LokPilot 5 manual: ¡°But only when the sound is switched on. You can set the start-up delay of the LokPilot 5 decoder in CV 252 in steps of 65ms.¡± Interesting that the units are 0.063 sec instead of 0.25 sec.
?
You can access CV252 using the JMRI single CV programmer.
?
I still cannot find it in the LokPilot 5 Basic instructions which say ¡°A list of all decoder parameters can be found in the de?tailed manual for the LokPilot 5 Basic, which can be down?loaded from our website www.esu.eu in the ?Downloads? area.¡± I can¡¯t find that detailed manual anywhere. Anyone know where it can be found?
From: Mark Granville <mfgranville@...> Sent: Tuesday, May 06, 2025 10:03 AM To: '[email protected]' <[email protected]> Subject: Re: Virtual sound setup
?
Ted, Definitely better asked in the LokSound group. All my locos have LokSound. None have LokPilot so I don¡¯t have direct experience. The on-line manuals for LokPilot 5 and LokPilot Basic are not helpful. I can¡¯t find a mention of starting delay in either one. But my understanding is that the starting delay feature was put into later firmware versions of LokPilot V4 and the LokPilot 5/DCC. You might try CV167. That seems to be the usual one used to set starting delay time (units of 0.25 sec) in the LokSounds.
