Buffering commands to handle fast incoming traffic while dealing with an operation that is currently underway is basic programming 101. I am surprised that this hasn't been done in these decoders. It isn't as though it is a hard problem to solve, just a little extra programming of some basic operations.
On Fri, 2 May 2025 at 14:11, louis.dirosso via <louis.dirosso=[email protected]> wrote:
Thank you for the invitation!
before you go chewing out NCE, try to remember that the signal decoder are built without any sort of compatibility or NMRA standard to meet.?
?
The light-it decoder is intended to be used with a handheld NCE throttle and when it is, it works well. at no point was it designed to interface with JMRI and I would imagine not designed to accept the commands as JMRI. When we start interfacing third-party hardware with other third-party hardware and it doesn¡¯t work, as frustrating as it is, we should not blame the manufacturer. We should blame the standard.?
I held onto my light, it decoders and will use them as accessory lighting for buildings streets, etc.
