Thanks to Both above for comments.
I wish i could close this thread,but im close but not completely done.
?
The problem i have is the Dispatcher runs the transit Nicely,but when it terminates or completes (my) SSL seem to go astray and i cannot continue.
The only way is to reset,by clicking the "remove direction sensors from SSl,and everything (signals )go back to looking ok
?
It seems when the train is ready to go (again)the facing signal stays red for some reason,as though something is in Block 3 TO,but it is clear.
Do? have any ideas,shall i re upload the data?
Thanks Again
Brett
