I have a case of some Zimo decoders behaving strangely. I am running JMRI 5.8 on an RPi.
?
On my Zimo decoders I like to add in the reduced momentum function. In the past, I’ve done this through the ‘Shunting/Uncoupling’ tab and it’s worked fine. However, I tried to do this on a Zimo MN170 decoder running Zimo version 4 software, and while the loco responds with reduced momentum when accelerating, on decelerating it seems to ignore the reduced momentum and instead it decelerates at a rate according to the Value of CV4.
?
I had this issue with a Zimo MN180N18, also running software v40,?instead of using the ‘Shunting’ tab, I programmed in the reduced momentum using the new section in the ‘Acceleration & deceleration’ tab, and that decoder responded as expected with the reduced momentum. However, the issue persists with the MN170, and also a MX619 running software v39.?
?
Any advice or suggestions will be greatly appreciated?
