On Thu, Nov 7, 2024 at 07:46 AM, Dave Sand wrote:
The path speed controls aspect selection. ?The path speed is the lowest turnout speed and lowest "block" speed. ?Note: ?OBlocks are not defined in SML so their speed is not relevant. ?Blocks are normally defined in Layout Editor.
I've been adding some SML for my replacement customised signaling system and noticed the SML table shows speed values. The speeds aren't what I want - too low.
I think Warrants ignore these speeds anyway so that may not be an issue BUT if it was, where does SML get these speed limit values from?
I read the overview about the lowest speed along a path, however given I don't use layout editor how would it know?
--
H.O. Australia (Layout in Progress)
Digikeijs DR5000 LocoNet
JMRI v5.8 DecoderPro/Warrants/CPE/SML/LogixNG
Windows 10
