开云体育

  1. Jmriusers
  2. Messages
Single Messages Topics Expanded Polls

Locked Re: JMRI Error: Service mode programmer NCE is offline. #nce

 

开云体育

Hi En-TACT.

?

Forget I mentioned making the Cab Address of the USB Interface to “10”.

You’ll be using the USB Interface at the DEFAULT Cab Address of “3”.

?

Connect the USB Interface to the Laptop.

Using the Laptop’s Device Manager the List? will include a “Ports (COM & LPT)” selection, if the correct Driver has been installed for your Cable.

Click on the “Ports (COM & LPT)” selection.

Shown will be: USB-SERIAL CH340 with a COM Port Number. This also confirms the operation of your USB Cable.

The highlighted COM Port Number is what you need to enter in the Decoder Pro’s Preferences “Connection” Tab for the Serial Port.

Also Check TICK the “Additional Connection Setting” box then select a Baud Rate of 19,200.

Then select “SAVE”?

?

If you cannot get connected, include a “System Console” printout under the Hep Tab in Decoder Pro.

?

Regards

Marcus

?

From: [email protected] <[email protected]> On Behalf Of En-TACT
Sent: Friday, 27 September 2024 12:23 PM
To: [email protected]
Subject: Re: [jmriusers] JMRI Error: Service mode programmer NCE is offline. #nce

?

It was changed to from COM10 COM3 after the screenshot.

?

How do I change the cab address of the USB interface to 10 - sorry I'm new.


Virus-free.
Join [email protected] to automatically receive all group messages.