I installed the decoder and it does run correctly as loco number 3. I wanted to change the loco number so I used "New Loco" , "Read type from decoder" steps to try to add it into DecoderPro.
The "Create New Loco" panel shows this .......
?
Whether I choose "All" or "Matched Only" the screen shot above is the only result. ? I looked through Digitrax website and discovered there is a retired DN147A. I think its safe to say the DN147 currently in DecoderPro is the DN147A which Digitrax retired in 2002.
The DN147A was replaced by the DN163A1
The DN163A1 has been replaced by the DN147A1 which is what I have purchased a week ago.
So we have DN147's and DN147's .......... I'll refer to what I have as DN147A1 (2024)?
?
I think the version number is what is holding DecoderPro from identifying the decoder correctly.
I don't want to change DecoderPro from version 4.26 because all of the 5.XX versions I have tried have a problem with identifying ports when I try to connect.
4.26 works great ! ?Is there a way I can update part of DecoderPro 4.26 when the version numbers from Digitrax becomes available ?
