At 6:08 PM +0000 7/22/02, sotars wrote:
Bob
I have just tried to control a loco with Windigital 8.5 and it works
so the Com port is set up OK.
Yes, it's pretty clear that everything is communicating.
Can Windigital 8.5 program decoders? If so, that means that the command station will accept programing commands, and there's something wrong with what DecoderPro is sending.
Also, could you try several of the programming modes to see if you're encountering a limitation there? Perhaps the Set 02 can only do "direct mode", for example. To check this, there is a set of radio buttons at the bottom of the screen on which you select the decoder type. They say things like "Paged", "Register", etc. Pick each one in turn and hit the decoder "ident" button to see if it works.
Bob
--
--------------
Bob Jacobsen (Bob_Jacobsen@..., 510-486-7355, fax 510-495-2957)
Bob Jacobsen