I thought I had gotten around this with the latest version of Steve's Raspberry Pi access point but that causes other problems (
/g/jmriusers/message/215532).? I tried to research the use of the colon (:) as a delimiter to indicate location in turnout user names.? Unfortunately, I found very little other than the parameter in Engine Driver.??
Is there anyplace in the turnout table, general parameters, WI Throttle server, etc. where I need to specify the use of this delimiter?
Is there a problem if I put the colon in some user names and not others?
If I have turnouts with user names of "YCLSF4" and "Y:CLSF3".? ? ?(One with, one without colon.)
? ? Then in Engine Driver, enter the name by typing "Y..." the "Y" doesn't show, and I continue with "CLSF4" i end up with "CCLCLSF4" displayed.
? ? And I type "Y:CLSF3": again Y not displayed, so I get "CLSF3".
This was on the Raspberry Pi downloaded 4/16/2019.??
Panel Pro: 4.17.3 + R12ded
Engine Driver: V2.35.169
I will be going down to the club (Tuesday, unless I get some suggestions earlier) and delete all turnouts, then re-add with user names without any colons.? ?
If fixing this requires an upgrade to later release, then I will need an answer to the other problem referenced above..??
Many thanks,
Clark
