Thank you. When the panel starts normally all turnout signal heads and occ sensors are red and, as you say, will stay red until the turnout is changed or an occ sensor goes active.
What happened on this panel was some of the signal heads were removed from the panel when opened and some heads went black, as though the head had just been placed on the panel with no SSL attached.
I just tested the recreated panel and all worked correctly. Next, I will see what a few power cycles do.
On Sun, Feb 2, 2020 at 10:27 AM Ken Cameron <kcameron@...> wrote:
John,
Keep in mind this about startup of signals.
1. It requires some input to change to trigger it thinking about what to
display.
2. If an input is not in a valid state, it stays at stop. So if any turnouts
are not CLOSED/THROWN or sensors not ACTIVE/INACTIVE, you won't get the
signal working.
