I am using the Layout editor to control signals and turnouts through an SPROG II.
Only signal decoders (NCE light-it) and accessory decoders (DCCconcepts AD1-HP) are connected to the DCC signal.
I also use MERG Cbus for occupancy detection.
?
Initially, after poweron, the system enters a state where accessory commands are not sent when changing a turnout.
The USB led on the SPROG II is then dark, and when changing a signal there is a short flash and the signal decoder changes.
Pushing a turnout on the panel moves the turnout on the screen, but there is no LED flash and the actual turnout does not move.
?
I have to set power OFF and restart JMRI once to enter a state where the turnouts will work.
In this state the USB led flashes continuously, sending FF 0 FF, and the accessory commands are sent in-between when pushing a turnout icon.
Signals work fine in this state also.
?
Also, if I leave the DCC power ON and then quit JMRI, it will enter the wrong state on restart.
?
Using ver 4.17.7 on windows 7.
?
Any clues, anyone?
?
Torgrim
?
