On Sat, Dec 7, 2019 at 10:06 AM, <forfoum@...> wrote:
This hysteresis is the amount of change from BEMF before it moves to next (+/-) notch.? Default is 80 (0-255). For use in "Prototype Throttle Mode" only.
Marc: I'm not familiar with TCS but from what you say their manual is not using the word "hysteresis" as it is generally defined. As Chuck says, hysteresis exists when one value of an input results in different values of an output depending on whether that input value was set by increasing a lower value or reducing a higher value. In decoder terms, Notch 2 speed would be different when notching up from 1 than notching down from 3. Hysteresis is what's left over after all the time delays of momentum have faded away when making a speed change. It is different to momentum but could mask it so confuse and complicate the process of speed matching.
Jan
