Peter,
There are a lot of errors during loading of this panel. ?The block routing had references to very long turnout user names that did not exist. ?
I have reset the block info and uploaded an updated xml file.
Dave Sand
----- Original message -----
From: "peter.s.drury via Groups.Io" <peter.s.drury@...>
Subject: Re: [jmriusers] Integrating JMRI to my MERG CBUS Layout #panelpro #layouteditor
Date: Monday, November 25, 2019 3:08 PM
I have added the above Layout Editor file which is the first stage building my JMRI file. A point to note is that the turnouts in the Fiddle Yard North are all 'Internal' System names and use 2 sensor feedback. The reason for this is to provide maximum flexibility or route setting which will be carried out by adjusting MERG CBUS. The layout in the Editor file represents what I see on my control panels. The turnouts are switched by the sensors. If you look at the Sensor table, I have added in the comments section the turnout reference numbers (e. FYP5, FYP6 etc. Set the sensor pair of each turnout for the change to be made.
I would appreciate any comments/suggestions.
?Peter
