Ken,
You da man!
All jumpers, baud 19,200 and AIU cab addresses of 4-6 work.
Not sure where you live, but I owe you a dinner!
Many Thanks,
Russ
toggle quoted message
Show quoted text
On Nov 21, 2019, at 6:43 PM, Ken Cameron <kcameron@...> wrote:
?I would suggest that you use all four jumpers on and change your baud rate
to 19,200.
Next, I presume you confirmed the USB version by looking at the JMRI log
during startup?
Then, make sure the AIU has a valid address set. I'd suggest trying 3 first
for the address.
Add the sensor to JMRI, I'd use the address value and :1 for the value. So
3:1 for the first sensor. I'd add the box to set a range and give it a 14.
This way all your sensors are created.
Then try toggling a sensor with a wire from the common pin on the AIU to the
input pin, try more than one. Do any of the sensors change?
Last would be including your Help->Console Log, cut/paste it into the email.
It will tell us lots if something isn't working right.
-Ken Cameron, Member JMRI Dev Team
www.jmri.org
www.fingerlakeslivesteamers.org
www.cnymod.org
www.syracusemodelrr.org
