Hello,
My question is new, but fits the subject line.? I'm new to this group, JMRI, DCC++ and DCC.? JMRI is successfully seeing the Arduino and I'm able to turn the decoder startup sequence on and off, reset values.? The only values I've tried to adjust are the Long Address(reset value from 3 to 33) and the Master Volume Control.? These seem to have saved properly.? I didn't want to change anything more exotic than that before proceeding.
When I open a throttle instance and associate it to the decoder(directly connected to the output, not yet installed in a loco), the only control that works is to be able to start and stop the decoder sounds(same in DecoderPro).? The decoder just runs the idle sequence.? All values predefined on the decoder are reflected in the throttle instance, such as Bell, Horn, Short Horn, etc., but the decoder does not respond to the simple commands, such as Bell, Horn, etc. Also when adjusting the throttle, the sound pitch does not change. I'm not sure if this is enough information to go on, but any help would be greatly appreciated.?
Here is what I'm running:
- JMRI-Windows 10 with associated throttle.
- Arduino DCC++
- Tsunami2 TSU-PNP
- 12v wall wart power supply for the track voltage
Thank you,
Russ
