Richard,
On 11 Nov 2019, at 6:28 PM, Richard_vanRaay via Groups.Io <richard_vanraay@...> wrote:
Dave and Ken. I have set up Light-It that is switching on and off through the PowerCab Accy. I have tested it to turn on an LED then a Nano. Success for me! It has an address of 555 .
That's good but I suspect you haven't isolated the Nano from the DCC bus this time.
I have connected a 4N25. I think this separates two circuits. The Nano does not light up anymore. Why do I need this?
Richard, you need to draw a rough circuit of what you have done, photograph or scan it and upload it to a new album in the Photos area of this group.
Steve Spence tried to show you a suitable circuit but must have attached it to an email. Attachments are stripped. Steve, could you please upload it to a new album in the Photos area?
I have researched and browsed through JMRI and looked through PanelPro, Option, Tables and gone through everything to try to work out where to go next.
I guess I am moving forward.
Thanks for your help.
I will reread the previous posts and keep trying to work out how to switch the Light-It through JMRI.
No one has yet posted how to connect your Sensors to the Light-It pseudo-turnout you need to create (with an address of 555) in the Turnouts Table. I'm afraid I can't help there, but there are plenty of others who should be able to help you.
Dave in Australia
