Test setup using a DCS51, Zephyr x, with locobuffer USB.? Using a single turnout to test on a breadboard.? Without a connection to the Pi except as providing power to the Arduino the Zephyr is able to actuate the turnout servo from an initial power on situation using switch t/c buttons. After hooking up the Pi and starting panel pro in autodetect mode (finds the hardware fine) I cannot throw the switch using the panels created.? I have created both internal and loconet turnouts and connected both to the switch on the panel (one at a time) but the switch does not operate.? At this point I cannot throw the turnout from the Zephyr any more.? I have to repower the Zephyr and disconnect the loconet usb to regain control.
The last time I used my laptop using windows 7 it all worked fine.?
It appears to me there is some issues with the Pi and Loconet and Zephyr I cannot get a handle on.
Being that this explanation is as clear as mud, I hope someone has some pointers try.
