Hi to all:
Today I was setting up some signals through JMRI and lost communication to my DCS240.? It had been working fine.? Loconet Monitor shows that buttons on the throttle are hit but there is no communication back from JMRI to the Loconet (cannot control turnouts, signals, or configure/read any Loconet device.
I am using a Lenovo laptop YOGA 730 running Windows 10.? The only COM port available is COM3 which has the driver from Digitrax: mchpcdc.inf
I tried reinstalling a generic Windows COM driver and then reinstalled the Digitrax one but no effect.? I had a similar issue several months ago and installing the COM port driver worked.? Today there is no effect.
Any ideas?
Bob
