Hello Anders.
?
I wrote the wrong address on "SW_REP: address 201 state: closed" should be 112.
My setting was Roco, Roco Z21 in Preferences now I added Digitrax, BT Locobridge.
I got another tab in table sensors named LokoNet where I put my sensors.
Now I get the feedback "INPUT_REP: address: 202 state: LO" in Monitor LocoNet in JMRI.
Now the blocks in JMRI also work.
When I look at the logs Z21XpressNet, X21LocoNet and LocoNet then only the Loconetlog responds when I run into a block.
I read a submitter that TC silver had to recalculate the feedback after a formula when it was INPUT-REP but not when it was SW_REP could there be such a problem?
Thank you for the tip about going on Bluetooth? now it works.
?
Regards.
Bosse
