Since you didn't mention how you are setting up your panel, I am going to state that it appears you are using the layout editor. I have used the panel editor without ever having a problem. Could you please define which editor you are using. It will clarify your question.
Thanks,
Nick Kulp
"I'm not a failure. I started at the bottom and I found it easily attainable. Life is too short to set unattainable goals"
- Nick Kulp
On Sunday, July 28, 2019, 05:27:33 AM EDT, Renton Charman via Groups.Io <renton.charman@...> wrote:
I am using Cobalt SS point motors which allows two point motors to be operated simultaneously with the same address. When I have tried to add points to the JMRI control panel on my Mac I can add the first post and control ok. However when I then try to add the second point and give it the same address I get an error warning that the address is already being used. I can control both points on the layout together clicking on the first point but I have no animation of the second point on the panel. Is there a way of doing this?
