Dave in Australia
Thank you for your most helpful reply.
Since you are an expert in ESU Decoders, I have another question concerning that same decoder. (Doesn't really match this topic, so I changed and expanded it a little):
Lighting (bw/fw) of this loco equipped with this decoder does not correspond to the direction the loco is moving.It is just the other way round. Of course one could alter that by changing the motorleads. but I would prefer to do that by changing the CV 29 value.
However, any change normal --> inverted in the "Motor Sheet" will have no effect and seems not to be accepted by the decoder. Same applies for direct manual change of the CV value. ( bit 0 = 1, bit 1 = 2, so the value should be 3).
By the way, i'm working with SPROG II v4. I am not very experienced, but think this should not be the reason.
Any idea?
Thanks for help and regards to "Down Under"
Joern
