Dave, ?thanks for all your help. I have almost finished putting signals on my panel and getting them to work correctly. As of right now only 1 is a light it decoder. I do have the rest of the decoders now. My question is, is there a way to edit the signals
to change them to the Light It? Or do I need to delete and replace them? ?I went in to the edit screen and didn¡¯t see a way to change them once I have the light it¡¯s in, but I may have overlooked it.?
Michael
On Nov 22, 2018, at 5:03 PM, Dave Heap <
dgheap@...> wrote:
toggle quoted message
Show quoted text
That's why it's better to configure an NCE Simulator connection when away from your NCE hardware rather than using Infernal for definitions. The system prefix is the same, you don't have to change any definitions and you can easily swap either way.
Many (if not most) other systems also provide Simulator connections. That's what they are for.
On 23 Nov 2018, at 11:13 AM, Michael Murphy <
smurfmm@...> wrote:
Once these are in, is there a way to go in and change the hardware from internal to NCE? Or do I need to take out each mast and replace it with NCE? ?I know the light it decoder is only good for one head and I¡¯ll need to for each switch.
