The max speed is just that, max if all signals are at there max, it gets adjusted by the signals, but never higher than the max. It's the minimum speed taking into account speed limits for curves, turnouts, blocks etc, between 2 points regardless of signals. The final speed used takes into account signal aspect, speed factors, max for loco etc.
Setting all the speeds in Warrents to 100 totally defeats the purpose. You set you curve speed to medium, a diverging turnout to slow etc.
If you are not using speed profiles, the final throttle setting will be not quite right, as all speeds will be 100% throttle as the throttle will be set to aspect speed (now always 100) divided by max speed for signal system (now always 100).
Steve G.
toggle quoted message
Show quoted text
On November 19, 2018 11:34:50 AM EST, Torben Cox <torben.cox@...> wrote:
Steve
As per my reply to Fraser, things are much improved now thank you - looking 3 sections ahead has certainly helped.??
However, surely having the max block speeds on the SML logic table calculated on panel load can't be right.? That means that any block set to caution on switch on will have that low speed ruling it for ever, as it seems to be the dominant number.
The only way I can make it usable is to set all the speeds in the Warrants table to 100 and then save, restart the program and reload the panel.? Then after SOD go back into the Warrants table and set all the speeds up again.
That can't be what's intended - OR what have I missed please.? ? ?(All blocks and turnouts are set to Global max)
Thanks
Torben
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
