Dave,
Thank ycallinou very much for persevering with me.? Where I am at is as follows - I cannot find how to print out a Logix as you have so you will have to take my words for this.? The times are exaggerated to be completely visible.? The actions are as follows:
set?trigger sensor inactive
set signal 38 RED on route being crossed (should be red this is just safety)
set crossover (turnout 6) to thrown after 10 secs
set turnout 7 thrown to thrown after 20 secs
set 1 sensor illuminating block after 30 secs
set 2 more sensors illuminating blocks on route
set signal 42 to clear (signal controlling route)
15:35:38.860: Accessory 36 Normal direction (ON) ..... this is the first signal
15:35:38.870: command completed successfully
at this point the second two blocks illuminate
15:35:38.870: Accessory 42 Normal direction (ON) .... this is the final and route clear signal way out of sequence
15:35:38.901: command completed successfully
15:35:48.887: Accessory 6 Reverse direction (OFF) .... 10 secs delay
15:35:48.887: command completed successfully
15:35:58.902: Accessory 7 Reverse direction (OFF) .... further 10 secs
15:35:58.902: command completed successfully
after a further 10 secs the final (and intended first) block illuminates
I am not sure how "logical" this is - but its what I get.
I can delay sensor setting - but not signal mast settings. So I still cannot get the signal to illuminate after the route is set up?????????
Thanks again.
Iain
?
