What Nigel said, me to.
Hover over throttle? slider, right click
Show speed steps, OK
Change speed steps
Hover over throttle, right click
Change to slider, hit OK.
From memory, this has been happening now for a few years, not
sure how to fix it permanently. Hopefully someone will tell us
how. Rick.
On 9/6/2018 3:56 PM, Nigel Cliffe
wrote:
toggle quoted message
Show quoted text
I¡¯ve met that (a long
time ago) if the speed steps on the JMRI throttle are set
to 28, rather than 128 steps.??
?
Nigel
?
?
?
From: [email protected]
[mailto:[email protected]]
On Behalf Of tim4780 via Groups.Io
Sent: 06 September 2018 17:28
To: [email protected]
Subject: [jmriusers] Loco Motor cuts out at around
30% full throttle
?
Hi, hope someone can help me. I'm using a
SPROG3 and JMRI 4:12. I guess I must have changed something
but don't know what. The symptom is than as I increase the
throttle using the slider the loco motor speed increases but
at around 30% the motor cuts out. The same thing happens in
PanelPro and DecoderPro and I get the same effect on both
Windows7 and Linux (Raspberry Pi)
Any suggestions gratefully received.
Tim English
