On Sun, Sep 2, 2018 at 12:41 PM Bob Jacobsen <rgj1927@...> wrote:
What do you use to connect the MacBookPro to the command station?
If it¡¯s a PR4, check this page:?
Bob
> On Sep 2, 2018, at 9:23 AM, canoephil <canoephil@...> wrote:
>
> Group,
> I have a Digitrax DCS 100 command station, PowerPax, new MacBookPro, and JMRI version 4.12 installed.? My connections are good because I have been programing RR-cirkits SignalMan boards in PanelPro. I am now trying to read my locomotives on my programing track to add the engines to my roster and program them in JMRI.? The programing track is connected properly because I can program the engines.? When I open DecoderPro and open the "New Loco" window to find the engine decoder, DecoderPro tries to read CV 8, but fails.? I have tried Bachmann and Athearn Genesis engines.? Any suggestions?
> Philip Rockwood
