Benny,
Thanks for the added files. ?The panel xml file now loads without any errors.
- The 40 to U2 appears to be a NX problem.
- The 31 to 33 turnout issue applies to both NX and signal mast logic. ?This implies an issue with block routing.
- I am not able to re-create the ¡°station¡± problem because I cannot find a sensor pair that goes straight through with no intermediate sensors.
What is the trick for getting the sensor icons to work in local mode? ?I am currently manually removing the Disable from the icon.
The NX implementation is quite unique. ?Now that I can set and clear routes, I hope to identify the issues.
Dave Sand
On Sep 1, 2018, at 1:11 PM, Benny Tj?der <etxbct@...> wrote:
I have ziped it now.
/Benny
Den l?r 1 sep. 2018 kl 18:57 skrev Dave Sand <ds@...>:
Benny,
I am also going to need the custom components located in the resources folder, and maybe the jython folder. ?These are located in the same?directory as the panel xml file. ?It works best if you zip the folders and their contents and upload the zip file.
Dave Sand
> On Sep 1, 2018, at 11:41 AM, Benny Tj?der <etxbct@...> wrote:
>?
> The xml file and the picture are uploaded now.
>?
> /Benny
>?
> Den l?r 1 sep. 2018 kl 18:13 skrev Dave Sand <ds@...>:
> Benny,
>?
> Attachments are removed from postings. ?You will need to upload your picture to the photos section. ?It would also be helpful if you could upload the?panel xml file to the ProblemsBeingWorkedOn folder.
>?
> Dave Sand
>?
>?
>?
> > On Sep 1, 2018, at 10:53 AM, Benny Tj?der <etxbct@...> wrote:
> >?
> > Hi,
> > I have downloaded the RPi-JMRI image and installed on a new SD card.
> > No problem to get it working. Downloaded my layout made in 4.12.
> > It started up and have connection to my railroad.
> > Raspberry Pi is running JMRI 4.13.2
> >?
> > The problem is if I select a route over two turnouts the turnouts are both thrown but the route shows thru both turnout in closed position, which?should be the best route.
> >?
> > The route table shows thrown path as active, but closed path as reserved.
> >?
> > I attached a picture showing the route table and the layout with the route reserved.
> > Turnout 27 is two right handed turnouts (27a and 27b) ?faced each other.
> > Turnout 26 is similar as 27 but two left handed turnouts.
> > The route table is from turnout 27a (block 27a).
> > Block 27as is between signal 31 and turnout 27.
> > Block 27acd is the block after a closed turnout (towards turnout 26 in closed position).
> > Block 27ab is the block in between 27a and 27b turnout.
> >?
> > In turnout table both 27a, 27b, 26a and 26b are thrown.
> > The main path thru all these turnouts are set to closed (default).
> >?
> > I have seen other strange behavior in EntryExit routing. Sometime it selects a route from one track down and then one track up instead of going?the shortest way on same track.
> >?
> > /BR
> > Benny
> >?
>?
>?
>?
>?
>?
