Albert,
Is your system Power Pro or Power Cab?
- If Power Pro, AIU broadcasts need to be disabled and baud rate for the serial port needs to be set to 9600 (both in SETUP COMMAND STATION). Also no AIU cab address can conflict with any throttle cab address - they all use the same cab address space. The Show NCE Cabs command will show you what is happening there. Can you see all your throttles and AIUs at unique addresses?
- If Power Cab, the first sentence above is inapplicable.
Looking at the JMRI system console can tell you/us a lot about the connection status. Likewise the NCE Command Monitor output (enable Timestamps and Show Raw Data as this can help in relating to any System Console messages).
The New England Convention 2018
toggle quoted message
Show quoted text
On 9 Aug 2018, at 6:36 PM, john Wragg <
teamwragg@...> wrote:
Have you checked the NCE monitor in JMRI to see if it is correctly receiving the output from the AIUs? it could be a problem with the USB interface board or the cable
Is the speed of the connection set the same in JMRI and the NCE USB?
