¿ªÔÆÌåÓý

  1. Jmriusers
  2. Messages
Single Messages Topics Expanded Polls

Locked Re: I am unable to read what type of decoder from the program track and mainline on LokSound and Broadway Limited decoders. I can read the Digitrax decoders.

 

It is in any QSI decoder locomotive window.? But since you're not detecting the decoder type you're not getting to the one of these windows unless you are manually selecting a decoder type, you will only see the QSI Misc tab if you selected one of the QSI decoders. It is a decoder setting not a JMRI setting.

The verbal feedback setting only applies to QSI decoder equipped locos, the decoder used in early Broadway Limited locos (along with many other makes).? Does not apply to later Broadway Limited locos since they now use decoders of their own design (first Blueline, then Paragon2 and now Paragon3).? This setting also does not apply to any LokSound decoder.

Michael Mosher
Webmaster, ECSFM
Member SFRH&MS
DCC Master PVSMR

On 8/8/2018 10:05 AM, cwt2168@... wrote:
Is the QSI Misc tab under the Edit then Preferences? If it is I am not finding it.

-----Original Message-----
From: [email protected] <[email protected]> On Behalf Of Michael Mosher
Sent: Wednesday, August 8, 2018 8:41 AM
To: [email protected]
Subject: Re: [jmriusers] I am unable to read what type of decoder from the program track and mainline on LokSound and Broadway Limited decoders. I can read the Digitrax decoders.

"Verbal feedback" is for QSI decoders only and is on the QSI Misc tab and is called "Programming Verbal Acknowledgement". It's bit 0 of CV 62. But it only applies to Ops Mode programming (POM), QSI decoders never have verbal feedback when on Service Mode programming on program track.

Michael Mosher
Webmaster, ECSFM
Member SFRH&MS
DCC Master PVSMR

On 8/7/2018 10:47 PM, cwt2168@... wrote:
Ken, I found 1, 2, and 3. They were all good. Where do I find the
"verbal feedback" option at? Also are you saying to remove the grain of wheat bulb?
I also have gone back to 4.12 version. I have also tried without the
PowerPax and I still get the same error, " no response from loco". So
it "JMRI" does not tell me what type of decoder it is. So when it
tells me this I can not go into the programing mode in JMRI to program
the address to the engines.
Join [email protected] to automatically receive all group messages.