Tony
In the programmer it's under tab "sound", set "CV write sound feedback" to disabled. That will set bit 6 of CV 245.
Steve G.
On July 29, 2018 11:52:13 PM EDT, AD <bklyns_baseball_club@...> wrote:
What should cv 246 be set to ?get best results
Tony
Hi
Check cv245 data bit 6 . I dont know if applies to all there decoders but applies to a lot. This allows programming track read write without errors, or boosters.
Steve G.
On July 29, 2018 3:48:43 PM EDT, Classic Auto Portraits <
classicautoportraits@...> wrote:
Dear Tony,
I too have encountered issues with the Broadway Limited units. One
Paragon2 PA1 in particular will not reset from it's 03 default. I
have come across mention of "Blast Programming" (see below) by
Digitrax, for decoders that "Require more current," but this looks
like it will only work with the Zephyr series.
I'd like to know more about the PTB100 track Booster.
Regards,
Robert Diepenbrock
On 7/28/18 8:33 AM, Roger Merritt
wrote:
Tony,
? ? My past experience with the Paragon locos was they had
capacitors in them and that soaks up the short write signal.? Had
to get a Track Booster to program those properly.? Using a PTB100
track Booster with my Digitrax DCS100 command station.
Roger
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
