Tim,
SML is signal mast logic.
I always use automatic discovery. I then test using simulated occupancy sensors and manual turnout settings to verify that the logic is correct. The most likely failures are caused by double cross-overs.
On your layout, I deleted the existing transit, sections and SML. I also used the Block table "Paths >> Delete Paths¡" option. I then saved the panel xml file, stopped and re-started PanelPro. After a lot of changes, the block routing can get out of whack. This creates a new set of block routes, which is the basis for SML.
I then used the signal mast logic table to generate the signal mast logic and the sections. The section generation also creates the direction sensors for each section.
After those steps were done, I created a transit, a train and ran it around the layout using occupancy sensor buttons on the panel.
Dave Sand
toggle quoted message
Show quoted text
On Jul 25, 2018, at 2:37 AM, timbancroft@... wrote:
Hi Dave,
Thanks for this, to be honest i thought i had gone through that process of getting each section right but its a bit of a steep learning curve, been at this for all of a week now!
I will look at the block assignment when i get back home, when you talk about the SML (assume this is signal mas logic) is the best way to let JRMI auto generate all of the logic or is human intervention better?
Many thanks for your time
Tim
